dieLCOMETRIC  moisture meter FOR LABORATORY RESEARCH

The laboratory dielcometric moisture meter FIZEPR-SW100.30 has a high sensitivity and accuracy of measurements, provides measurement not only of moisture but also of the complex permittivity. It can be used both for liquids and fine-grained bulk materials control.

Universal moisture meter

The dielectric moisture meter FIZEPR-SW100.11 is designed for measuring permittivity and moisture content in liquid and bulk materials. Moisture measuring range - from 0 to 100% - provides a wide area of instrument application.

MOISTURE METER FOR LIQUID MATERIALS

The moisture meter FIZEPR-SW100.20, -SW100.21, -SW100.12  is designed  to measure moisture in liquid materials, such as oil, fuel oil, petroleum, alcohol, coal-water slurry fuel (CWSF or CWS or CWF -  is a fuel which consists of fine coal particles suspended in water), sludge, etc. 

The device consists of an electronic unit and a sensor.

The sensor is made as a pipe section with flanges of stainless steel. There is a probe inside the pipe made as a flat-topped stick ​​of stainless steel of the same grade.

Moisture meters for high-conductivity materials

A new series of moisture analyzers (moisture meters) is designed to measure materials with high electrical conductivity such as salts, chemical sludge, sewage sludge, anthracite, ion exchange resins, etc. These analyzers can also be used to measure concentrations of salt, acid and alkali solutions.

Grain moisture meters

The FIZEPR-SW100 moisture meter is world's only non-nuclear moisture meter designed to measure moisture content in materials with large fraction sizes of up to 15 cm and more (ore, crushed stone, gravel, etc.).